October 8, 2026
Boom section control vs. spot-spray patch maps, explained

If you run a sprayer with section control and someone mentions a "patch map," it's easy to assume they're the same conversation. They're not. One keeps you from spraying ground twice. The other tells you whether that ground needed spraying at all.
Worth sorting out before next week's runs, because mixing the two up is how operators overpay for tech that doesn't do what they think it does.
What boom section control actually does
Boom section control uses GPS position to turn individual boom sections (or individual nozzles, on finer systems) on and off as the rig moves. It knows where the boom has already been, from this pass or an earlier one, and shuts a section off when that strip of ground is already covered. Point rows, headlands, odd-shaped field corners, end-of-pass overlap, that's the territory it's built for.
It's a geometry problem. The controller doesn't know what's growing in the field. It knows where the boom has physically traveled, and it stops double-application on the overlap. That's real chemical saved, and most ops leads running variable-width equipment already count on it.
What section control can't tell you is whether the clean strip of ground it just opened up actually has weeds in it. If the field is 90% clear and 10% patch, a section-control pass still lays blanket rate across the whole 90%, because as far as the controller's concerned, every square metre in its path is a target.
What a spot-spray patch map adds
A patch map comes from imagery, not boom geometry. UAV or crewed-aircraft RGB flown at 2 cm or finer separates weed from crop at leaf scale, and the output is a map of where the actual patches sit in that field, matched to the pass that flew it. The map tracks where the weeds are, independent of where the boom has already traveled.
That's the piece section control can't generate on its own. Section shutoff answers "has this ground been sprayed." A patch map answers "does this ground need spraying." Put them side by side and you can see why one doesn't replace the other: a field can have zero overlap and still get a full blanket rate if nobody's told the rig where the clean ground is.
The two work on different ends of the same job. Section control cuts waste at the boundaries and the overlap. A patch map cuts waste in the middle of the field, in the open ground between patches that never needed chemical in the first place. Run both and the chemical savings happen at the boundaries and inside the field at the same time.
Where this leaves chemical spend
Section shutoff has been standard enough for long enough that most contractors already have it priced into the job. It's the second half, the actual weed-vs-clean call inside the pass, that's still mostly done from memory and last year's scout notes. A per-pass patch map is built to fill that gap: a spray-ready view of which square metres in the field carry weed pressure, timed to the pass that's about to fly or just flew, instead of a blanket rate applied because nobody had a better answer for the spray window.
We're running this with pilot partners right now rather than shipping it as a finished product you can buy off a shelf, which is the honest way to say where it stands. Weed Mapping is building out that per-pass patch map capability for fields where spraying the whole thing doesn't make sense anymore.
If spot spraying the patch instead of the field is where your next contract is headed, get in touch about joining the pilot.